Safety should always be the top priority when installing a new wall oven. Professionals are trained to handle electrical or gas connections, ensure proper ventilation, and comply with local building codes.
One of the most common problems is a power outlet that needs to be put up to the job or an undersized gas system. Your certified technician will check all of these issues before proceeding.
Turn Off the Power
If you’re installing a gas oven, a certified technician will inspect your existing gas line for leaks. They will also check that your current wiring can handle the demands of a new oven. A professional electrician can help upgrade your wiring for safety and compliance if it cannot.
If your new oven is electric, your installer will turn off the power to your kitchen at the circuit breaker panel before beginning installation. They will use a non-contact electrical tester to ensure the power is completely off before proceeding.
Your professional oven installation Gaithersburg MD, will then carefully connect all the electrical wires according to the user manual and the manufacturer’s guidelines. They’ll also wrap and secure any excess wiring with cable ties for safety. If your electrical system uses aluminum wiring, a professional installer will use only connectors approved for aluminum wiring to avoid fire hazards and other safety issues. This step ensures your oven is properly connected and wired to meet industry standards and factory requirements.
Remove the Old Oven
If you’re getting rid of an old oven, it’s essential to disconnect and dispose of it properly. It would help if you had the old oven hauled away by junk removal professionals. However, this can be expensive and is only sometimes possible if you’re replacing an existing range or wall oven.
To remove an oven door:
- Start by opening it about a quarter of the way and keep your hands in position on both sides.
- Pull and lift the door evenly until the hinges start coming off the oven’s frame.
- Once the door is off, place it on a flat surface so it doesn’t fall and break.
Most reputable appliance manufacturers require professional installation to validate their warranties. Hiring experts will guarantee precise installation and help avoid expensive repairs and replacements. Whether you need a single or double oven installed, it’s best to have it done by pros.
Install the New Oven
While it may seem daunting, installing an oven can be done with careful preparation and meticulous care. Hiring a professional gas fitter who is experienced and knows how to handle electrical wiring is always recommended for the best results.
First, locate the electric junction box. Ensure that this is shut off and not in use (so you don’t get severely injured).
Next, measure the cabinet cutout opening to determine whether or not your new oven will fit. Using the measurement details provided on the oven’s reference sheet, measure from the top and bottom edges of the cabinet cutout to see how much room is left.
Once you’ve confirmed that your new oven will fit, it’s time to install it. Carefully slide it into place, avoiding pinching or damaging the wires. Also, be sure that it’s level to prevent uneven heating. Finally, reactivate the circuit breaker to bring the new oven online.
Test the Oven
A hot or cold oven can make all the difference in your meals, so testing for even heating is essential. Your certified electrician will be able to help you find out where your hot or cold spots are by placing a thermometer in several locations inside the oven and measuring the temperature.
Once the oven has cooled down, the electrician will check for continuity by connecting a multimeter to the terminals on each of the two elements (one on top and one on bottom). Each oven’s element may have different connections, so consult your multimeter manual for specific instructions.
Once the electrical connections are secure, turn the circuit breaker back on and give your new oven a test run. If everything is working correctly, it’s time to enjoy your delicious home-cooked meals!
